User's Manual Part 2

ManualsBrandsR-tron ManualsElectronicsiDen Mini Wireless Repeater

iDEN MINI

User’s Manual -17-

2.2.6. HPA (High Power Amplifier)

The High Power Amplifiers (HPAs) amplifies the transmitted signal from a

base station at the final stage of the repeater and vice versa.

Figure 10. HPA(High Power Amplifier)

Summary of content (7 pages)

PAGE 1
iDEN MI NI 2.2.6. HPA (High Power Amplifier) The High Power Amplifiers (HPAs) amplifies the transmitted signal from a base station at the final stage of the repeater and vice versa. Figure 10.
PAGE 2
iDEN MI NI 3. Hardware Installation The installation procedure is as follows: Check List of Items Mounting Grounding RF Connection Power up 3.1 Check List of Items Index 1 2 3 Items iDEN MINI Power Cord Screws for Mounting Q’ty 1 1 4 Items 1 2 Figure 11.
PAGE 3
iDEN MI NI 3.2 Mounting iDEN MINI is easy to mount using the assembled mounting bracket, which has Ø9 holes for the provided 5/16" fixing screws. Figure 12. Mounting CAUTI ON Firmly aff ix the equipment on the wall of a building and Check necessary.
PAGE 4
iDEN MI NI 3.3 Grounding WARNI NG Dangerously high voltages may occur and damage the equipment if the equipment is not grounded properly. A rod on the left side is intended for a building ground. Connect the ground cable to the rod. Figure 13. Grounding 3.4 RF Cable Connection User’s Manual a. Connect a cable from a donor antenna to the DONOR ANTENNA Port. b. Connect a cable from the SERVICE ANTENNA Port to a repeater’s service antenna.
PAGE 5
iDEN MI NI Figure 14. Configuration: RF Cable Connection 3.5 Power Up a. Connect the power cord. b. Plug the power cord into a wall outlet. c. Switch on. d. Check if the green LED at the bottom turns on. Figure 15.
PAGE 6
iDEN MI NI 4. Command and Control through the Hyper Terminal 4.1 Setting for Command and Control through the Hyper Terminal Figure 16. Local connection to the iDEN MINI Step 1 Open My Network Places. Step 2 Push the right button of mouse and select the properties.
PAGE 7
iDEN MI NI Step 3 Click the properties of TCP/IP. Step 4 Set the values and OK as the following. Close all windows.