User's Manual

Glossary

The following is a list of abbreviations and terms used in this manual.

Abbreviation Definition

AC Alternating Current

ANT Antenna

ATT Attenuator / Attenuation

MHU Main Hub Unit

RU Remote Unit

EHU Extension Hub Unit

C.W Continuous Wave

GUI Graphic User Interface

LED Light Emitting Diode

PLL Phase-locked loop

PSU Power Supply Unit

MCU Main Control Unit

UDC Up-Down Converter

DL Downlink

GND Grounding

RF Radio Frequency

RSSI Received Signal Strength Indication

TEMP Temperature

DC Direct Current

UL Uplink

VSWR Voltage Standing Wave Ratio

CLC Cable Loss Compensation

ALC (Automatic Level Control)

ALC feature prevents the repeater from exceeding its maximum output power by reducing the gain

automatically. ALC is used to adjust the gain to an appropriate level for a range of input signal levels.

ASD (Automatic Shutdown)

Automatic shut down protects the repeater from oscillation or excessive input signal and eliminates

any degradation to the network.

There are three parameters: ASD Level, ASD Time, and ASD Iteration.

If the output power exceeds higher than the “ASD LEVEL”, the repeater will shut down for “ASD

TIME” seconds and it will turn the amp back on to measure the output power again. If this repeats at

“Iteration” times, the repeater will shut down completely.