User's Manual

4.4.3 Network

Click Network on the left menu bar.

Network Setup

• Cascade Code: Type the pre-assigned cascade code. Otherwise, you cannot access the

system setup.

• Location Information: Enter the latitude and longitude of information, otherwise you cannot

access the system setup. You can input values either in Decimal Degrees or Degrees-Minutes-

Seconds.

[Example]

(‘N/S’ | ‘E/W’) ddd.dddddd: (Latitude: N 39.006967 Longitude: W 94.532306)

• Heartbeat Interval: Sets the time to transmit the Heartbeat to the NMC Server.

(Default value is 20 minutes. For this operation test, temporarily reduce the value to 1 minute.

After conforming the heartbeat report, set the value back to 20 minutes.)

• Product Information: This is for manufacturer use only. Do not change this value.

• IP Mode: Has two modes, Auto and Static. The factory default is set to IP Mode Auto.

It can be assigned IP automatically if the IP Mode is Auto. IP Mode has to be

changed to Static if user wants to set up the IP directly.

IP Mode is able to use if Remote port accessed and IP Mode has to set up the static

if Remote port accessed.