User's Manual

R-TRON Proprietary & Confidential Page 13
and GUI. The Communication protocol is a RS-232C protocol between the SNMP board and the
PC serial port which is set up by the GUI. The Current RCU transmit speed is fixed at
11,5200bps. As you can see in the above picture, you can select the proper COM port and then
click the ‘ START’ button. Now the RCU communication is started. If there is no problem with the
communication, the Rx LED will light up green with the Tx and Rx lighting up green, alternately.
4.7 Check setting figures
As shown in the above picture, you can check the Site ID(Cascade Code) , WNMC Phone
Number , WNMC IP Address , SNMP Version and Modem Phone Number. When you change
the current GUI settings, you can input the needed numbers in the white boxes and click toggle
switch to store the values.
4.7.1 How to set Parameter value
4.7.1.1 Cascade code Input
ex) Cascade Code which is given by a wireless operator : test01
Type Cascade code in white activated box. Click “SiteID Set” button.