User's Manual
#2':75'4/#07#.86GEJ5WRRQTV
Band Select
G Band select sets the digital filter to the center frequency and bandwidth of the local service
for which the repeater is intended to amplify. Likewise, all other signals outside of the selected
Center Frequency and Bandwidth are not amplified.
G The user can select one or two or three distinct section within the iDEN band. Each of the 1st,
2nd and 3rd filter blocks can be set to 1MHz to 18MHz of Bandwidth(800MHz). For 900MHz
Bandwidth is 1MHz to 5MHz. Only the downlink center frequency is set by the user. The uplink
center frequencies are automatically set in acordance with the downlink frequencies.
G Filter Rejection allows user to change the digital filter characteristics. Normal rejectrion is
satisfactory for requirement of Frequency rejection over 55dBc(delta 1MHz) and High regection
over 65dBc(delta 500KHz).
G Frequency information is a reference for seting the center frequency and band width (refer to
section 8.1).
G Offset(KHz) is a feature that allows the user to customize the position of the high frequency
band edge. The feature provides additional seperation, if needed, from an adjacent frequency
band(i.e. Cellular A Band)
GUI System Setup
Easy Setup
Step 1. Click Apply after setting Center Frequency and Band Width in use.