User's Manual
#2':75'4/#07#.86GEJ5WRRQTV
¾ SYSTEM
• Cascade Code: Type the pre-assigned cascade code (site I.D); otherwise, you cannot
access the system setup.
Set up for multiple bands.
One repeater with installed NCU is designated as the master control. The other repeaters will
connect to the master via RJ45 cable.
The master web GUI will display the other repeaters if the connection is successful.
ȄG Cascade code 1 box of SYSTEM in Network setup.
ȄG When adding repeaters refer to the RJ45 cable connection below.
ȄG Add Cascade codes to the cascade code table under the SYSTEM section of the Network
setup page.
Cascade Code Setting Chart
Repeater Repeater 1 Repeater 2 Repeater 3 Repeater 4
Cascade code Cascade Code 1 Cascade Code 2 Cascade Code 3 Cascade Code 4