User's Manual

APEX730 USER MANUAL V1.0.00 Tech Support: 1-888-317-8766
27
4.7 GUI Status
The status page display system, control, and alarm information.
When you set any value on the Control page the change will be reflected on Status page.
<Status>
4.7.1 System
• Firmware version and location are displayed under Repeater Information.
• The Band Information setting, set from the control page, is shown in bold font.
4.7.2 Operating
• DL Path Monitor displays input from the donor antenna circuit, output power at repeater
server antenna port, and downlink amplifier gain.
• UL Path Monitor displays input from the server antenna circuit, output powr at repeater
donor port, and uplink amplifier gain.
• Isolation Status shows isolation value (dB) between the donor antenna and server antennas.
• Available gain allowed by isolation measurement. Available gain is derived from the
antenna isolation value plus 15dB. Full system gain (90dB) is available if the antenna
isolation value is at least 105dB.
4.7.3 Alarm
• If an alarm occurs, the alarm LED on the repeater will turn on.