User's Manual

APEX730 USER MANUAL V1.0.00 Tech Support: 1-888-317-8766

4.5.1 System Control

• Easy Setup is a fast start function. The function measures isolation, detects input level and

assign gain to achieve maximum output power. The function ends with the repeater set to

amplify siganals in both directions within the confines of the band selection. Before runing

easy setup, set the center frequency and bandwidth

Maximum output power requires at least -60dBm input power and suficient antenna

isolaiton.

• Isolatoin Check can be executed at anytime to measure isolation between the donor and

server antennas. Isolation Check momentarily disables service. Isolation check automatically

runs when factory default is initiated.

• Factory Default restores the amplifier to its initial state. The function ends with amplifiers

off, AGC mode off, gain set to minimum(60dB) and UL gain offset set to 0dB. Band

sellection and all other system parameters are not changed. The featurs is usefull in claering

abnormal conditions.

• System Reset cycles the microporcessor unit. The function is similar to switching off/on the

repeater power switch.