User's Manual

APEX1933 USER MANUAL V1.2 Tech Support: 1-888-317-8766
20
5.4.2.1 SYSTEM
• Cascade Code: Type the pre-assigned cascade code. Otherwise, you cannot access the
system setup.
¾ Set up for multiple bands
Equipment with NCU installed is designated as the master control. The other
equipments will connect to the master via RJ 45 cable.
The master web GUI will display the other equipments if the connection is successful.
1) Cascade code 1 of SYSTEM in Network setup:
Put Direct LAN Cable into Equipment 1 port and connect to NMS port.
2) For adding equipments refer to the RJ 45 cable connection below.
Input Cascade codes to the cascade code table under the SYSTEM section.
• Cascade Code Setting Chart
Equipment Equipment 1 Equipment 2 Equipment 3 Equipment 4
Cascade code Cascade Code 1 Cascade Code 2 Cascade Code 3 Cascade Code 4