Specifications

air supply. Check for adequate ventilation around machine

6. Erratic cut – Torch spitting when cutting

Check torch consumables and replace if necessary as per instructions earlier in this

manual

Check if correct amperage for thickness of metal, if to slow travel speed or to much

cutting power, increase speed of cut or reduce cutting amperage. (When machine

senses no metal left to cut it will switch of main cutting power and switch on HF pilot

arc, this is the HF pilot arc restart)

Water contamination in torch head, Check for water in water trap at rear of machine, if

water is present, drain air compressor, clean water out of air lines, empty water trap by

pressing water release button on bottom of air regulator water trap. Fit new

consumables as per instructions earlier in this manual

Plasma Torch Consumables parts list

R-Tech Torch Spares

Plasma 60HF

Part No.

Electrode P40-EL

Cutting Tip 1.0mm 40 Amp P40-CT1

Ceramic Cup P40-CC

Spring, Stand off P40-SS

Torch Head –Hand Held P40-THH

Torch Complete Hand Held 6M P40-6MHHT

Plasma 60,80,100 HF

Electrode P60100-EL

Cutting tip 0.8mm 30 Amp P60100-CT08

Cutting tip 1.1mm 60 Amp P60100-CT11

Cutting tip 1.3mm 80 Amp P60100-CT13

Cutting tig 1.5mm 100 Amp P60100-CT15

Shroud P60100-SH

Torch Head hand held P60100-THH

Torch Head Machine P60100-THM

Torch Complete 6m Hand Held P60100-6MHHT

Torch Complete 6m Machine type P60100-6MMTT