Specifications

7.1 Compact and Remote Models
Ensure the machine is correctly plugged into the main circuit.1
Proper PPE must be worn2
Ensure workplace safety such as fume extraction is in place3
Switch machine on using On/Off switch4
Open gas cylinder and set gas flow rate by depressing gas 5
purge button
Set voltage and wire feed speed (the tables included in this manual 6
can be used as a guideline for voltage and wire speed selection)
Voltage is set by adjusting voltage knob (v) on wire feeder/7
power source
Wire feed speed can be set independently by adjusting the “wire 8
speed” knob
Inductance can be changed by adjusting the 9
on the wire
feeder/power source. The value will be displayed (whilst welding) on
the power source
Welding wire can be fed through the torch by selecting “Wire Inch” 10
button on the wire feeder/power source.
NOTE
Refer to the Control Panels section for a complete explanation of
all functionalities.
7.0 Smootharc ADVANCE Operation
21BOC Smootharc Advance MIG 200C/275C/275R/350R Operating manual