Specifications

remember the last settings if it is turned off.
How to setup the Synergic and Manual functions:
1. Turn unit on. Wait for it to go through the power up cycle.
2. Select the MIG icon with the Process Selector button.
3. Select the wire diameter of the wire being used. Selecting ALT defaults unit to full manual mode.
4. Select the filler wire type. Fe= Steel, Al= Aluminum, SS= Stainless Steel.
5. Select 2T or 4T function. 2T is simply press and hold the torch trigger to start and activate the torch.
6. 4T requires the trigger to be pressed to start the arc. Once arc is started the trigger should be released
to continue weld. The trigger should once again be pressed, held briefly and then released to
terminate the arc when ready.
7. If used in the manual mode (ALT), select the appropriate wire feed speed and voltage to match wire
type and size. Listen for a steady frying sound while welding to give you a key as to when it is adjusted
properly. If used while in Synergic mode, select the desired wire speed and the voltage will adjust
automatically. If a minor voltage adjustment is felt like it is needed while in the synergic mode, simply
turn the volt-age knob to increase the voltage from the automatically selected setting. If more wire feed
speed is desired, the unit will default back to the automatic setting as the wire feed speed is increased
or decreased. However, manual control can once again be asserted over the automatic setting by
simply turning the voltage knob once again.
8. Use the Wave Form control to select the desired arc qualities and adjust the arc qualities, whether a
stiff, pen-etrating arc with a narrow bead profile and slightly more spatter, or a wider more fluid puddle
that easily wets in with low amounts of spatter. Overhead welding usually requires a more stiff
penetrating arc. Flat welding will accept a wider more fluid puddle.
- 20 -