D7210 Touch less Flush Sensor Module Installation Instructions (Wireless, Capacities) Cover. Dual push button Cylinder assembly Control box RF Module. Battery box ® Battery box holder f 1 Cistern Body. Bolt Flush Valve.
D7210 Touch less Flush Sensor Module Installation Instructions (Wireless, Capacities) 1.Take out all related accessories (refer to the accessories list). 2.Remove white cap and refill tube firstly. Air tube Then, insert bracket into the overflow pipe (The outer ] diameter of overflow pipe is @26mm33mm.
D7210 Touch less Flush Sensor Module Installation Instructions (Wireless, Capacities) 4. Cover the lid of the water tank and the installation is completed. Note: After installation, please power on and operate once to reset the whole module to the initial state. 5.Troubleshooting Issue Cause Solutions Low flush volume 1. The installation position of the actuation rod is too high and it is not pressed on the flush button properly. 2. The air pipe is not installed in place resulting in air leakage. 3.
D7210 Touch less Flush Sensor Module Parts List (Wireless, Capacities) Part Name Photo Quantity Color Note Wireless RF Sensor module 1 connection,wave hand to flush Air Tube 1 Transparent Used to connect control module and cylinder kit Installation bush Suitable for slim tube flush valve Drive assembly Including bracket, cylinder kit and bolt Control box assembly Including control box, battery box and hanger User Manual and Warranty Card
D7210 Touch less Flush Sensor Module Operation Instructions (Wireless, Capacities) |. Specifications Power PCs AA alkaline batteries (battery box) Supply + PCs AAA alkaline batteries (wireless sensor module) Operating . temperature Maximum sensing 2-cm distance II. Instructions Sensor Flushing: When hand within the sensing range <1s, a half flushing is activated. When hand within the sensing range 21s, a full flushing is activated (Re-sensed after hand away). The indicator lights up when sensing received.
D7210 Touch less Flush Sensor Module Operation Instructions (Wireless, Capacities) 3. Flush volume adjustment Hand wave adjust: 1.Within 5 minutes of power-on or exiting hand wave adjustment mode, 5 consecutive effective sensing at intervals less than 2S (cylinder movement completed to next hand wave). Gear is successfully adjusted if action performed automatically after no operation for 108 after 5 times of flush. 2 Adjust level to the maximum if the flush volume corresponded is not the maximum.
D7210 Touch less Toilet Flush kit Drive Module Introduction The D7210 Touch less flush kit drive module is a new product developed by our company based on the general increase in hygiene awareness around the world. Especially during the outbreak of the epidemic, people need a touch less controlled flushing module to prevent cross-infection during the epidemic and daily contact with bacteria during the manual flushing.
