Specifications

Standard Charger
Caution: the following instructions are intended for the
36v charger supplied with the machine.
Do not use
any non OEM charger with this machine.
1. Transport machine to a well ventilated area for
charging.
2. Turn the machine off.
3. Hinge opens the tank to expose the batteries.
(See picture to the left)
Caution: (always wear eye protection when batteries
are exposed)
4. Check the water level in each battery. Do not
charge the machine unless the water is slightly higher
than the plates. If needed, add enough
distilled
water to 1/2” above the plates. Do not over fill.
Batteries can overflow during charging. Replace
caps before charging.
5. With the grey (175) charger plug disconnected
from the machine, plug the charger power cord into
a grounded 110 volt standard wall outlet.
6. Connect the grey charger plug into the battery
charging port
(A) located on the seat pedestal.
7. The charger will automatically begin charging,
and automatically shut off when fully charged
(Check gauge)
8. After the charger has turned off, unplug the grey
charger plug from the machine and disconnect the
charger from the wall outlet.
9. Recheck the cell level after charging. If needed,
add distilled water up to the correct level. Be certain
to replace the caps securely and to wipe off the top
of the batteries.
Standard Battery Charging
Charger Specifications
Output voltage of 36 volts. (Standard)
Output current of 36 amps max. (Standard)
Input voltage of 110 volts/60 Hz. (standard)
Automatic shut off circuit.
Made for deep cycle batteries.
Danger:
always charge batteries in a well ventilated area.
Batteries emit hydrogen gas. Explosion or fire can result.
Keep sparks and flame away. Shield eyes when servicing
batteries and avoid contact with battery acid.
Leave access panel open when charging!
PAGE 24
A