Specifications

One pass scrubbing
Steps: (see picture below)
1. Turn machine on with the key switch.
2. Lower squeegee by pressing the switch.
3. Lower scrub head to the floor, use the
top half of the brush switch.
4. Adjust the solution +/- to the desired
setting. (start at half way).
5. Begin scrubbing by depressing the
foot pedal slowly and then to the speed
required. (Not shown)
6. Start scrubbing at the #1 or # 2 marks,
do not use the #4 or #5 marks without
management's approval.
7. To operate machine in reverse,
simply switch the reverse switch to
the reverse position, back up alarm
may sound and your reverse speed
is set to roughly 70% of forward.
8. To stop the machine, let off of the
foot pedal and the machine will
stop automatically. (Not shown)
9. Depressing the
"uni-touch" button activates
the solution, vacuum, and brushes
simultaneously.
Operation
Pre-cleaning check list
Read and understand the safety section on
page 5 and 6 before operating machine.
1. Check battery condition gauge on
the Central Command II LCD screen.
Make sure batteries are fully charged
before using.
2. Check the condition of pads or brushes.
3. Check the condition of the squeegee blades.
4. Transport the machine to the filling
station. Raise the scrub head and
squeegee when transporting.
5. Turn machine off.
6. Open solution fill door on the top of
the tank and fill the tank up with
clean water or
"approved" detergent. For help call
Powercat Solutions at 414-745-9337. Foam in the
recovery tank is usually an indication of excessive soap.
(See picture below.)
7. Add cleaning chemical. Use the proper
dilution ratio indicated on the bottle.
Note: Use only nonflammable commercial
cleaning chemicals.
PAGE 19
Solution Fill Port
Solution Fill
"Sight Tube"
1
2
3
6
7
4
9