Specifications

PAGE 13
Leveling Scrubdecks
Leveling Disk Scrubdeck
1. Drive machine to a flat level surface and
turn machine off.
(See picture to the left)
2. Deck should be raised off the floor.
3. With the shrouds off, measure from the ground
to a parallel surface on all four corners of the
scrubdeck.
(See picture to the left)
3. If the measurements are not the same the
deck is not level and needs to be adjusted.
4. Loosen the (2) locking nuts
(4) and adjust
the hexagonal arm
(5). (See picture to the left)
5. Extending the adjustable arms raises the
front and lowers the rear of the scrubdeck.
Measure & Retighten.
(See picture to the left)
Leveling Cylindrical
Scrubdeck
1. Drive machine to a flat level surface and
turn machine off.
2. Raise the deck off the floor.
3. Measure from the ground to a parallel edge
on all four corners of the scrubdeck.
4. If the measurements are not the same the
deck is not level and needs to be adjusted.
5. Loosen the locking nut
(4) and turn the
hexagonal arm
(5) on each side of the
scrubdeck to level it.
(See picture to the left)
6. Extending the adjustable arm raises the
front and lowers the rear of the scrubdeck.
Measure & Retighten.
(See picture to the left)
Measure from
deck to floor
Measure from
deck to floor
4
54
4
5
Measure from
deck to floor
Measure from
deck to floor