Owner`s manual

3.1 Montage du siège auto
Comment fixer votre siège auto au
moyen de la ceinture à 3 points de
votre voiture :
Þ Placezla coque du siège 11 en
position d'assise verticale (voir 5.).
Astuce ! Le siège ne peut être
ouvert qu'en position verticale.
Þ Placez sur le siège auto sur le siège
du véhicule en l'orientant vers la
route.
Þ Poussez le levier de déverrouillage
gris 1 vers le haut et tirez
simultanément sur le milieu du
bord supérieur de la coque.
La coque 11 se désenclenche.
Þ Basculez la coque 11 vers l’avant
jusqu'à ce qu'elle s'enclenche
correctement.
Þ Sortez la ceinture en tirant et
passez-la entre la coque 11 et la
partie inférieure du siège 12.
Þ Enclenchez la languette dans le
fermoir de la ceinture 2 du véhicule.
CLIC !
Þ Introduisez la sangle ventrale 3
dans les guidages de sangle rouge
vif 4 situés des deux côtés de la
partie inférieure du siège 12.
Attention ! Ne pas torsader la
sangle.
Þ Passez la sangle diagonale 5 au-
dessus du crochet de sangle 9.
3.1 Installing the child
safety seat
To secure the child seat using the
3-point belt of your vehicle proceed
as follows:
Þ Adjust the seat shell 11 to the
upright seating position (see 5.).
Note: The seat can only be opened
in the upright position.
Þ Place the child safety seat facing
forward on the vehicle seat (in the
direction of travel).
Þ Pull up on the grey release lever 1
and at the same time pull at the top
in the centre of the edge of the
seat shell.
The seat shell 11 disengages.
Þ Tip the seat shell 11 forward until it
latches.
Þ Pull out the vehicle seat belt and
place it between the seat shell 11
and the seat base 12.
Þ Engage the buckle tongue in the
vehicle seat buckle 2 with an
audible
CLICK!
Þ Place the lap belt section 3 in the
light red belt guides 4 on both sides
of the seat base 12.
Caution! Do not twist the belt.
Þ Guide the diagonal seat belt section
5 over the top of the belt hook 9.
3.1 Einbau des Auto-
Kindersitzes
So sichern Sie Ihren Kindersitz mit
dem 3-Punkt-Gurt Ihres Fahrzeugs:
Þ Verstellen Sie die Sitzschale 11 in
die aufrechte Sitzposition (siehe 5.).
Tipp! Der Sitz lässt sich nur in der
aufrechten Position öffnen.
Þ Stellen Sie den Auto-Kindersitz in
Fahrtrichtung auf den Autositz.
Þ Drücken Sie den grauen
Entriegelungs-Hebel 1 nach oben
und ziehen Sie gleichzeitig oben in
der Mitte am Sitzschalen-Rand.
Die Sitzschale 11 rastet aus.
Þ Kippen Sie die Sitzschale 11 nach
vorn bis sie festhakt.
Þ Ziehen Sie den Autogurt heraus
und führen Sie ihn zwischen der
Sitzschale 11 und dem Sitzunterteil
12 durch.
Þ Rasten Sie die Schlosszunge im
Auto-Gurtschloss 2 ein.
KLICK!
Þ Legen Sie den Beckengurt 3 in die
hellroten Gurtführungen 4 an
beiden Seiten des Sitzunterteiles
12.
Vorsicht! Gurt nicht verdrehen.
Þ Führen Sie den Diagonalgurt 5
oberhalb des Gurthakens 9 vorbei.