Instruction manual

14
OMB15
If Stroller Pulls RIGHT
If your stroller pulls RIGHT, turn
tracking knob clockwise up to one
half turn.
REPEAT roll test and adjust as
needed until stroller rolls straight.
SELECT SHOCK SETTING
NOTE: Every time stroller is folded,
stroller shocks default to 18 kgs
position (Position 1).
1. Remove Child From Seat
2. Set Shock Setting To Position 2
Depress shock release knob and
simultaneously pull toward back of
stroller, sliding knob into position 2.
Knob will “snap” into place when in
correct position.
REPEAT on opposite side.
Position 1: Child 18 kgs or less
18 kgs
SNAP
Position 2: Child 18 to 25 kgs
25 kgs
18 kgs
SNAP
SETTING PARKING BRAKE
The parking brake prevents the
stroller from moving while loading
and unloading. The parking brake is
not designed as a stopping brake.
The parking brake
is not designed as a stopping
brake. The brake should not be
used to slow or stop the stroller
because doing so could cause the
stroller to stop abruptly, resulting
in loss of control.
Do not park on
inclines. The parking brake is
intended to park the stroller on flat
surfaces only. Parking on inclines
may result in tip over or runaway
stroller.
To set the parking brake, press the
brake bar down into the locked
position with your foot on the red
foot pedal – making sure the locking
pin fully engages the locking disk.
Tracking Knob