Installation Operating Maintenance & Spare Parts End Truck RT/RS Manual
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 EN PS03447 MASTER Rev: 18.3.2003 I Read the instructions supplied with the hoist before installation and commissioning. F Keep the instructions in a safe place for future reference. Table of content 1 Safety instructions......................................... 3 1.1 Safety instructions for preparing to install the end truck ......................................................... 3 1.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 1 Safety instructions 1.1 Safety instructions for preparing to install the end truck I • • • • Follow these instructions when preparing to install the end truck: Ensure that the installation personnel are competent and qualified, and they are provided with adequate instructions for carrying out the installation work.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 2 End Truck RT09/RT11/RS11/RT14/RS14 c_ec09a 2.1 General End trucks are designed to carry the crane or hoist as a pair. Any other kind of use must be designed case by case. The end truck is suitable for both indoor and outdoor use. 2.2 Main components One of the main components of end truck is the wheels.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 2.4 Inspection and service procedure for end truck The following inspections and servicing procedures must be performed at regular intervals. See 'Inspection and servicing intervals' section for the inspections and servicing schedule. • Check the tightness of the bolts on the end truck. • Check the wheel for excessive wear. F Some wearing on the wheels is normal.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 Only authorized or adequately-trained personnel may carry out service or repair work. If any defects or abnormalities are observed, they must be investigated and corrective action must be taken in accordance with the instructions. 6/29 R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 3 End Truck RT20/RT25/RT32/RT50 c_ec2050a 3.1 General End trucks are designed to carry the crane or hoist as a pair. Any other kind of use must be designed case by case. The end truck is suitable for both indoor and outdoor use. 3.2 Main components One of the main componens of end truck is the wheels.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 F The joint plate bolts are just loosely preassembled at athe factory and must be properly tightened when building the crane. 3.4 Inspection and service procedure for end truck The following inspections and servicing procedures must be performed at regular intervals. See 'Inspection and servicing intervals' section for the inspections and servicing schedule.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 of a crane or a hoist, or by the end of the stated number of calendar months, whichever comes first. If the end trucks are being used in intermittently, they should be inspected before being used again. F Iffrequent.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 4 Lubricants I Use of a low-grade or incompatible lubricant could damage the bearings. Use only the lubricants recommended by the manufacturer. Factory-installed lubricant unless otherwise specified: Trade name and number Mobilgrease XHP 222 4.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 5 Recommended tightening torques Recommended tightening torques for screws and nuts. Tightening torque Size M4 M5 M6 M8 M10 M12 M14 M16 M18 M20 M22 M24 M27 M30 Strength 8.8 Nm 2.7 5.4 9.3 23 45 77 125 190 275 385 530 660 980 1350 Ft lb 2.0 4.0 6.8 17.0 33.0 56.6 92 140 202 283 390 485 721 993 Strength 10.9 Nm Ft lb 4.0 2.9 7.9 5.8 14 10.3 33 24 66 48.5 115 84.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 6 Spare Parts 6.1 RT09 Pos.
R&M Materials Handling, Inc.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 6.2 RT11/RS11 Pos.
R&M Materials Handling, Inc.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 6.3 RT14/RS14 Pos.
R&M Materials Handling, Inc.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 6.4 RT20 Pos.
R&M Materials Handling, Inc.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 7 3000001833 BUFFER 2 1: Buffer type = H 7 3000001834 BUFFER 2 1: Buffer type = P 7 3000001835 BUFFER 2 1: Buffer type = I 7 3000001836 BUFFER 2 1: Buffer type = S 8 3000002258 (3000001141) HARDWARE SET 1 20/29 R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 6.5 RT25 Pos.
R&M Materials Handling, Inc.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 7 3000001834 BUFFER 2 1: Buffer type = P 7 3000001835 BUFFER 2 1: Buffer type = I 7 3000001836 BUFFER 2 1: Buffer type = S 23/29 R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 6.6 RT32 Pos.
R&M Materials Handling, Inc.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 7 3000001834 BUFFER 2 1: Buffer type = P 7 3000001835 BUFFER 2 1: Buffer type = I 7 3000001836 BUFFER 2 1: Buffer type = S 26/29 R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 6.7 RT50 Pos.
R&M Materials Handling, Inc.
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 % : (937) 328-5100 FAX: (937) 325-5319 7 3000001834 BUFFER 2 1: Buffer type = P 7 3000001835 BUFFER 2 1: Buffer type = I 7 3000001836 BUFFER 2 1: Buffer type = S 29/29 R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
