Owner's manual

ManualsBrandsR&M Materials Handling ManualsHoistELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 10 Stepless

LM10 STEPLESS I&M MANUAL/EN/11.30.2010

64/99

This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that

may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.

7.12 Control Changes and Fuses

The layouts and wiring diagrams found within this section are for standard hoist controls. Stepless hoists are

available for 460 volt three-phase power supplies only.

Control Circuit Fuse

The control circuit fuse holder is located on terminal strip X1. The fuse holder top flips up to facilitate

changing a defective fuse.

Table 17. Control Circuit Fuse

POWER

CONTROL FUSE

SUPPLY VOLTAGE SIZE

3 – PHASE 115 VAC 630 mA