Owner`s manual

10
REV 4 0811041514
No. L-A2-02908
LOG PLACEMENT (continued)
REAL-FYRE GAS LOG SETS 16"
Place the front and rear bottom logs on the grate
(Figure 8). The face with the bark effect should face
out into the room. The longest log is placed in front.
The log locators insure that adequate space between
the logs are maintained for a cleaner burn.
PLACEMENT OF MIDDLE AND TOP LOG
Place the left and right middle logs on the bottom
logs as illustrated (Figure 9)
Right middle logLeft middle log
Figure 9
Place the front top log with one end resting on top of the
front end of the left middle log. The other end will rest
on the front bottom log. Place rear top log with one end
resting on top of the back end of right middle log. The
other end will rest on the rear bottom log (Figure 10).
Figure 10
Figure 8
Rear top log
Front top log
OPTIONAL BONUS LOG PLACEMENT
Your optional bonus log (Included with Emberwood
Deluxe, Emberwood Deluxe Designer, Golden Oak
Designer Plus and Split Oak Designer Plus Log Sets)
should be placed directly above the front or rear bottom
logs (Logs #1 and #2), so it does not extend into the
space between the front and rear logs (Figure 7).
Attach the COALS FYREBED (Part No. CHD-01) to
the burner by slipping it onto the back edge (center
left to right) with the perforated section facing towards
the back fi replace wall. (Figure 11a). Cover the surface
of the COALS FYREBED with the EMBER COALS
(Part No. EM-4, supplied with your Charred Series log
set) (Figure 11b). For best glowing performance, they
should be applied evenly and pulled slightly apart so
the fi bres are somewhat loose. (It is not necessary
to pile the entire bag of the EMBER COALS. More
EMBER COALS may be added after completion of the
entire installation).
Figure 11a
Part No.
CHD-01
COALS
FYREBED
CHARRED SERIES INSTALLATION
Figure 11b
Log styles and sizes will vary depending upon the Charred Series log set ordered.
Place the long bottom rear log (Log #2) on the back
of the grate with the fl at featureless side facing
the rear of the fi replace. Slide it forward to touch
the log locator. The two sections of the front log
(Log #1A & 1B) are placed on the front of the grate
with the charred sections facing each other and
approximately one inch apart at the top (Figure 12).
Slide them back against the log locators. The log
locators insure that adequate space between front
and rear logs are maintained for a cleaner burn.
Place the two curved logs (Logs #3 & #4) so that
one end rests on each front log section (Log #1A
CHARRED SPLIT OAK DESIGNER PLUS (SDP) layout shown.
LOG PLACEMENT
& 1B) and the other end rests on the rear log (Log
#2). The charred sections should be over the opening
between the front and rear logs. (Figure 13).
Place the small top charred logs (Log #5 & #6) so
they rest over the charred sections of the front bottom
log sections (Log # 1A & 1b) and on the two curved
logs (Log #3 & #4) (Figure 14).
Finally, place the curved top charred log (Log #7) to
rest on the two top logs at rear, but not encroaching into
the space between rear and front logs (Figure 15).
Note: The additional top log (Log #7) is not
available with 18” log sets.
Figure 7
Bonus log
above
rear log
7
EMBER COALS PLACEMENT