Owner`s manual

A. BEFORE LIGHTING, smell all around the unit

area for gas. Be sure to smell next to the ﬂ oor,

because some gas is heavier than air and will

settle on the ﬂ oor.

B. WHAT TO DO IF YOU SMELL GAS

1. Shut off the gas to the appliance.

2. Extinguish any open ﬂ ame.

3. If odor continues, immediately call your gas

supplier or the ﬁ re department.

C. Use only your hand to push in or turn the gas

control knob. Never use tools. If the knob will not

push in or turn by hand, DO NOT try to repair it.

Call a qualiﬁ ed professional service technician.

Force or attempted repair may result in ﬁ re or

explosion.

FOR YOUR SAFETY, READ BEFORE LIGHTING

1. STOP! Read the safety information above.

2. Lay a lighted long-stem match on the surface of the

decorative media near the burner ring (do not hold

the match in your hand) or use a lighted long-necked

butane lighter (Fig. 25-1).

3. Slowly turn the control knob to the ON position (see

Fig. 25-2). Your burner should light.

4. If the burner does not light before the match goes out,

immediately turn the control knob to the OFF position.

5. Wait approximately ﬁ ve (5) minutes to clear out any

gas, and repeat steps 1-4 above.

6. If your burner fails to light again, turn the control knob

to the OFF position and contact your dealer or gas

supplier.

7. To extinguish your gas burner, turn the control knob

to the OFF position. Be sure the control knob is turned

fully off to avoid any gas leakage.

OPERATING THE UNIT - LIGHTING AND EXTINGUISHING

MANUAL (MATCH) LIGHTING INSTRUCTIONS

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY

RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.

Fig. 25-1

Apply match - then turn on gas

OFF

Fig. 25-2