Owner`s manual

ManualsBrandsR.H. Peterson ManualsLawn and GardenOCR-27P

INSTALLING/REPLACING THE BATTERIES FOR

01 SERIES

To access the "D" battery pack, unscrew the access

plate on the left side of the control panel. Only unscrew

the large retaining screw. Grip the top half of the

access plate and pull it out to expose the "D" battery

pack (Fig. 11-4). Replace the old batteries with two

(2) new "D" batteries. Return the access plate into

the control panel. Screw in the large retaining screw.

To access the "AA" battery pack, unscrew and remove

the two (2) retaining screws on the control system.

Pull out the control system and then slide open the

battery pack lid as shown in Fig. 11-5. Replace the old

batteries with four (4) new "AA" batteries. Resecure

the battery pack lid and return the control system into

the control panel. Screw in the two (2) retaining screws.

CAUTION: ENSURE THE UNIT IS CONNECTED

TO THE GAS LINE AND HAS BEEN

TESTED FOR LEAKS BEFORE YOU

INSERT BATTERIES.

Fig. 11-4

"D" Battery pack exposed

Fig. 11-5

"AA" Battery pack exposed

Fig. 11-1 Fig. 11-2

INSTALLING/REPLACING BATTERIES (IF APPLICABLE)

INSTALLING / REPLACING THE SPARK

GENERATOR BATTERY FOR PIEZO LIT MANUAL

UNITS

To access the "AA" battery, unscrew the complete

generator cap (

Fig. 11-1). Withdraw the existing battery

and spring (Fig. 11-2) and detach the "AA" battery.

Insert the new battery (negative end ﬁ rst) into the

spring. Insert the battery and spring into the generator

and replace the cap, screwing down until snug. Do

not overtighten.