Owner`s manual

Fig. 20-1

Fig. 20-2

Note: Regular cleaning and servicing will be necessary to ensure proper ODS pilot operation and proper

burn characteristics.

A. Always shut off the gas to the unvented gas log set while performing service work.

B. Allow the unvented gas log set to cool before servicing.

C. Installation, service, and repair must be done by an NFI Certiﬁ ed or other qualiﬁ ed professional

service technician. The appliance MUST be inspected before use, and cleaned at least annually

to prevent burner shutdown, sooting, odors, etc. by a qualiﬁ ed professional service technician. It

must be checked for clean burning operation and proper ODS pilot appearance, with the correct

tools to service this unit. More frequent cleaning may be required. Excessive lint can build up on

this unit from carpeting, bedding material, pet hairs, or other particles in the air. It is imperative that all

control components and compartments, burner(s), and circulating air passageways of the appliance be

kept clean and free of all obstructions. The ODS pilot is especially sensitive to a dirty environment and will

not function properly if dirty. Make certain all air openings are clean and free of obstructions, including:

1. The air intake opening on the ODS pilot assembly.

2. The ODS pilot opening.

3. The air shutters on both the front/bottom ember burner and the rear/top main burner.

4. The ﬂ ash tube and its corresponding carryover port. Obstructions in or around the ﬂ ash tube may result

in the ember burner not lighting and/or an intermittent popping noise from the ﬂ ash tube.

WARNING: Failure to keep the primary air openings of the burner(s) clean may result in sooting and property

damage.

5. All of the ports on both the front/bottom ember burner and the rear/top main burner. (See the CLEANING

AND SERVICING section.)

D. Any safety screen or guard removed for servicing must be replaced prior to operating this gas

log set.

CLEANING AND SERVICING SAFETY INFORMATION

ODS pilot (in rear)

Main burner ports

Ember burner

ports

Gas valve

Carryover port location

(for ﬂ ash tube)

Flash tube

ODS pilot

opening

Air intake opening