Owner`s manual

GLOWING EMBER PLACEMENT

The Glowing Embers are supplied in a single bag (Fig. 18-1). It is important that the embers be used

in the designated application and that no additional embers be added. Open the bag and spread the

embers loosely along the entire length of the ember burner (Fig. 18-3). Break up any clumps

that may have developed during shipment, and make sure the embers are spread evenly over

the entire area. Bryte Coals are placed over the glowing embers, also spreading out evenly (Figs.

18-2, 18-3). Failure to follow these instructions will result in unsafe operation.

Important: Do not add any additional embers or Bryte Coals to this log set. Any additional

embers may cause unsafe operation.

CAUTION: Burn hazard. Logs will remain hot for some time after use. You must maintain the

log layout as shown to ensure proper operation of the log set. If you need to reposition

any log to maintain the proper layout, use heat-resistant gloves or allow logs adequate

time to cool before handling.

INSTALLATION (Cont.)

After setting the logs into position as described on the previous page, ensure each is properly and

ﬁ rmly seated. This unvented gas log set will not function as intended if the logs are not correctly

positioned. When placed properly, the ﬂ ames will not strike any portion of Logs

3, #4, #5, #6, or #7.

Periodically check the positioning of all logs to ensure proper log placement and stability. If any ﬂ ame

is striking Logs #3, #4, #5, #6, or #7, recheck log placement. Adjust to conform with instructions.

There must be no ﬂ ame impingement on these logs.

Fig. 18-1

Fig. 18-2

Fig. 18-3

LAVA-FYRE GRANULES PLACEMENT

Lava-Fyre Granules are provided as an aesthetic enhancement to the unvented gas log set and do

not affect its operation. Spread the Lava-Fyre Granules on the ﬂ oor of the ﬁ rebox around the front

and the sides of the unvented gas log set. BE SURE THAT NO LAVA-FYRE GRANULES ENTER

THE BURNER SYSTEM OR INTERFERE WITH THE BURNING OF THE LOG SET.