Owner`s manual

17
Log placement is critical to ensure proper performance of the gas log set. Be sure to follow the log
placement instructions carefully. Logs are placed the same way for all sizes of log sets.
1. Each log in the unvented gas log set is numbered to aid in the log placement procedures. Set the
front log (Log #1) and rear log (Log #2) in their approximate positions on the grate (as shown in
Fig. 17-1). The rear burner supports assist in the positioning of logs #1 and #2.
2. Position the front log (Log #1) so that the rear burner supports fi t tight against the back of the log
(Fig. 17-1). Ensure the grooves in the bottom of the log sit on the grate fi ngers.
3. Center the rear log (Log #2, left to right) and pull forward so the slots in the front of this log are
against the rear burner supports (Figs. 17-1,17-2).
4. Position the middle logs (Logs #3, #4, and #5) on top of the bottom logs. Place the logs so that
each log rests in the corresponding slots on the bottom front log and bottom rear log (see Fig.
17-3).
5. Position the two top logs (Logs #6 and #7) on the top of the intermediate logs. Position the top
logs by placing each top log into the slots of the intermediate logs (see Fig. 17-4).
INSTALLATION (Cont.)
Important: Carefully follow the detailed instructions below and on the next page for correct log placement.
LOG PLACEMENT
Fig. 17-1
Fig. 17-4
Showing the fi nished Golden Oak Designer (RD9)
above. The Split Oak (S9) and Forest Oak (FO9) set
will have an identical log setup and positioning.
Rear log
Front log
Top/rear
burner supports
2
1
-4
6
7
Fig. 17-2
2
1
4
6
7
543
Fig. 17-3
WARNING: Failure to position the parts in accordance with these instructions and diagrams, or failure to use
only Peterson Real-Fyre
®
controls, parts, and accessories that have been specifi cally listed or
certifi ed for use with this heater, may result in property damage or personal injury.
series 15 valve
shown