Owner`s manual
17
GLOWING EMBER AND LOG PLACEMENT
LOG PLACEMENT
WARNING
Failure to position the parts in accordance with these diagrams, or failure to use only parts
speciļ¬ cally approved with this unvented gas log set, may result in property damage or personal injury.
Carefully follow the detailed instructions on the next page for correct log placement.
The Golden Oak Designer (RD9) is shown.
The Split Oak (S9) has an identical log setup and positioning.
GLOWING EMBER PLACEMENT
The Glowing Embers are supplied in two bags (Fig. 17-1). It is important that the embers be used in
the designated application and that no additional embers be added. Open the bag and spread the
embers loosely along the entire length of the ember burner (Fig. 17-3). Break up any clumps
that may have developed during shipment, and make sure the embers are spread evenly over
the entire area. Bryte Coals are placed over the glowing embers, also spreading out evenly (Figs.
17-2, 17-3). Failure to follow these instructions will result in unsafe operation.
Important: Do not add any additional embers or Bryte Coals to this log set. Any additional
embers may cause unsafe operation.
Fig. 17-1
Fig. 17-2
Fig. 17-3