Owner`s manual

INSTALLATION (Cont.)

IMPORTANT

For all valves, the air MUST be purged from the gas line before the pilot will light properly. The time taken to do

this will depend on the length of gas line from the meter to the unit and the length of time since the unit or gas line

was last used (in the case of non-use during warm weather, for example). It may take from 3 to15 minutes before

all the air is purged and the pilot will light properly. This is done using different methods, depending on which valve

is ﬁ tted to the unit. Follow the LIGHTING INSTRUCTIONS in this manual for the speciﬁ c valve type.

A. G9-24/30(P) - Hold down control knob at PILOT (see Fig. 18-1).

B. G9-24/30-15(M)(P) - Hold in control knob at PILOT (see Fig. 18-2).

C. G9-24/30-12(M)(P) - Hold in control knob at PILOT (see Fig. 18-3).

CONTROL SETTINGS

We recommend that before you install the log set, you familiarize yourself with the control valve layout. This

will help you to be conﬁ dent operating the log set when fully installed. See the ﬁ gures below for typical control

positions.

Fig. 18-2

OFF IGNITION PILOT ON

Series15 remote-capable gas valve

operating positions

OFF PILOT ON

Read setting here

Series 12 remote-capable gas valve

operating positions

Fig. 18-3

OFF PILOT ON/HIGH ON/LOW

Manual gas valve

operating positions

Fig. 18-1