Owner`s manual

Note: To install the Real-Fyre

unvented gas log set, the ﬁ replace must have a gas-supply line

that has been installed by a qualiﬁ ed professional technician in accordance with all local

codes. Refer to the PARTS LIST when installing the unvented gas log set.

BE SURE THE GAS SUPPLY TO THE FIREPLACE IS TURNED OFF.

BEFORE PROCEEDING, CAREFULLY READ ALL OF THE IMPORTANT SAFETY

INFORMATION CONTAINED IN THIS OWNER’S MANUAL, INCLUDING:

A. PRE-INSTALLATION AND FIREPLACE PREPARATION SAFETY GUIDELINES.

B. VENTILATION AND CONFINED SPACE INFORMATION.

C. INSTALLATION SAFETY GUIDELINES.

CONNECTING THE GAS TO THE BURNER SYSTEM

WHEN USED AS A VENTED DECORATIVE APPLIANCE (PER ANSI Z21.60b-2004)

These gas logs may be installed as vented decorative log sets in compliance with ANSI Z21.60b-2004

and National Fuel Gas Code, Section 6.6. The minimum permanent free opening of the ﬁ replace

chimney or chimney damper must be at least 29 sq. in. based upon a minimum chimney height of

at least 15'. The chimney damper must be ﬁ xed in a manner to maintain the permanent free opening

at all times. To accomplish this, you may install a screw or bolt in the edge of the damper to prevent

closing, drill holes in the damper, or remove the damper.

INSTALLATION

Important: CHECK GAS TYPE (natural or propane). The gas supply must be the same

as stated on the gas log set rating plate. If the gas supply is different, DO NOT

INSTALL. Contact the dealer for immediate assistance.

Tools Required:

1. Adjustable open-ended wrench

2. Pliers

3. Propane gas–resistant pipe compound or Teﬂ on

tape

4. Soapy water solution & brush for leak

detection

5. Standard-head screwdriver

6. Manometer (recommended for checking gas

pressure)

Important: Be sure you have read and understand all safety precautions and warnings contained in

this manual.

This appliance is for installation in a solid-fuel-burning ﬁ replace (masonry ﬁ replace or manufactured

ﬁ replace) with a working ﬂ ue and constructed of noncombustible material.