Owner`s manual

CLEANING AND SERVICING (Cont.)

Air intake

openings

ODS pilot opening

Compressed

air duster

Flexible

nozzle

4. If the ODS pilot ﬂ ame does not burn as indicated in the instructions, extinguish the ODS pilot by turning

the valve to the full OFF position. Using a compressed air duster (commonly available at computer,

electronic or ofﬁ ce supply stores), insert the ﬂ exible nozzle through either air intake openings, insuring

that the nozzle is pointed toward the ODS pilot opening (see Fig. 21-1). Blow air through both air intake

openings to clear out any debris that may be in the system.

5. Re-light the ODS pilot and inspect it to be sure it is burning as shown in the instructions. If not, extinguish

the ODS pilot and turn off the gas supply to the gas log set. Using an adjustable or a

" wrench,

disconnect the ODS pilot gas line from the valve.

6. Insert the ﬂ exible nozzle of the compressed air duster and blow air into the input end of the ODS pilot gas

line to remove any blockages (see Fig.

21-1). Do not blow air directly into the ODS pilot opening.

Blow air in the direction of the gas ﬂ ow.

7. Re-install the ODS pilot gas line and check for leaks.

8. Light the ODS pilot to make sure it is operating properly (see the relevant LIGHTING INSTRUCTIONS

section).

9. If the ODS pilot still does not operate properly, it may need to be replaced with the same model as the

one on the vent-free burner.

Fig. 21-1

Fig. 21-2

ODS pilot location

Burner ports

Air shutter