Owner`s manual

4. Position the curved logs #3 and #4 on top of the bottom logs. Locate the logs so that they ﬁ t into the notches of the rear

bottom log and the front end of each log rests on the corresponding notches on the bottom front log (see Fig. 18-3).

5. Position the two top logs #5 & #6 on the top of the curved logs. Locate the top logs by ﬁ tting these logs into the

notches of the curved logs. Place the other end of the top logs into the notches of the bottom front log (see Fig. 18-3).

After setting the logs into position as described above, ensure each is properly and ﬁ rmly seated. The vent-free gas

log set will not function as intended if the logs are not correctly positioned. When placed properly, the ﬂ ames will

not strike any portion of the logs. Periodically check the positioning of all logs to insure proper log placement and

stability. If any ﬂ ame is striking the logs, recheck log placement. Adjust to conform with instructions. There should

be no ﬂ ame impingement on the logs.

6. Optional lava granules are available from the local Real-Fyre

dealer as an aesthetic enhancement to the vent-free

gas log set and do not effect its operation. Spread the lava granules on the ﬂ oor of the ﬁ rebox around the front

and the sides of the vent-free gas log set. BE SURE THAT NO GRANULES ENTER THE BURNER SYSTEM OR

INTERFERE WITH THE BURNING OF THE LOG SET.

Fig. 18-3

Note: Each log in the Real-Fyre

vent-free gas log

set has a number engraved in the back to

aid in the log placement procedures.

1. Set the front log #1 in it’s approximate position on

the grate (as shown in Fig.

18-1).

2. Center the front log #1 (left to right) on the grate

(Fig. 18-2).

3. Place the rear log #2 on the back of the ODS

mounting bracket so that the ODS cover ﬁ ts into

the cut-out of the bottom of this log (Fig. 18-1).

Slide the rear log #2 forward until the log sets into

position (Fig. 18-2). The rear log is designed

with a notch and position brace to maintain the

minimum distance between the front and rear

bottom logs, allowing for a cleaner burn and safer

operation.

WARNING: Failure to position the parts in accordance with these instructions, or failure to use only parts

speciﬁ cally approved with this heater, may result in property damage or personal injury.

LOG PLACEMENT

Fig. 18-2

Fig. 18-1

Carefully follow the detailed instructions for correct log placement

CAUTION: BURN HAZARD. Logs will remain hot for some time after use. You must maintain the log layout as shown

to ensure proper operation of the log set. If you need to reposition any log to maintain the proper layout,

use heat resistant gloves or allow logs adequate time to cool before handling.

Rear log

locks into

place on

ODS pilot

bracket