Owner`s manual

9
The following section addresses the installation of the burner
model directly to the gas supply.
IF THE BURNER IS TO BE INSTALLED WITH A PILOT KIT:
FOLLOW THE INSTRUCTIONS SUPPLIED WITH THE PILOT
KIT FOR SPECIFIC BURNER INSTALLATION INSTRUCTIONS.
REFER TO THE BURNER PARTS LIST WHEN FOLLOWING
THESE INSTRUCTIONS.
24" burner shown here.
BURNER INSTALLATION
1. MAKE SURE THE FIREPLACE GAS SUPPLY IS TURNED
OFF.
2. Locate the gas-supply stub inside the fi replace and remove
the cap, if attached (reference Fig. 9-2).
CAUTION: When removing the cap, make sure the stub does
not turn, loosening the connection inside the wall.
3. Remove the small adapter that is loosely connected to the fl ex
connector (included). Attach the adapter to the nipple found on
the bottom of the burner pan using a pipe compound resistant
to all gasses. Tighten securely. Then attach the fl ex connector
to the adapter. Tighten securely (See Fig. 9-1).
4. Place the burner system in the fi replace. Center the burner
in the fi replace. (Reference Fig. 9-3 for orientation.)
5. Be sure gas to the fi replace is off. Remove the large
adapter that is loosely connected to the fl ex connector. Attach
the adapter to the gas-supply stub using a pipe compound
resistant to all gasses. Tighten securely. Then attach the fl ex
connector to the adapter. Tighten securely (See Fig. 9-2).
6. LEAK TEST: Use a long-necked butane lighter, or lay a lighted
match next to the burner pipe, and carefully turn on the gas
supply until the burner ignites. Test at all connections for
leaks using the appropriate soapy water solution. If bubbles
appear, a leak is present. Turn off the gas and tighten at all
connections. Repeat until no leaks are present. If a leak
persists, turn off the gas supply and contact the local gas
company or dealer. NEVER USE A FLAME TO CHECK
FOR LEAKS.
Turn off the gas supply prior to proceeding.
The Real-Fyre burner system must be installed by a qualifi ed professional service technician. Instructions must
be followed carefully to ensure proper performance and full benefi t from the burner system. Check to be sure
the burner system is designed and labeled for the type of gas (natural gas only) supplied to the fi replace.
Fireplace fl oor must be level, clean, and smooth.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifi cally approved with this appliance may result in property damage or personal injury.
INSTALLATION
Fig. 9-3 Orientation
Fig. 9-2 Connect fl ex to gas supply
Fig. 9-1
Connect fl ex to burner
Adapter
Flex
connector
Flex connector
Adapter
(design
may vary)
Gas supply stub
Nipple