Owner`s manual

ManualsBrandsR.H. Peterson ManualsHome building and DecorG52-18/20-2V(P)A

GLASS / GEMS PLACEMENT

Fig. 15-1

Fig. 15-2

Fig. 15-4

Granules up

to burner

tube

Burner pan

Separator

screen

(Pack granules in pan

and around tubes)

(If long edges of screen rise up and do not

rest ﬂ at; bend them downward as needed)

Fig. 15-3

Separator

screen

Burner tubes

Granules level

Granules

sloped

Side view

Granules

sloped

Burner pan

BURNER PREPARATION

After hooking up the burner to the ﬁ replace gas supply and placing the

heat shield on the valve assembly (if applicable), the decorative media

(granules and glass / gems) must be added for the burner to function

as designed.

Note: Installation is the same for glass and gems. Glass

shown here. These instructions show sand granules being

used as a base for the glass, but only natural-gas burners

use sand. For propane burners, follow these instructions

using vermiculite.

WARNING

The burner and pilot (if equipped) must be OFF (fully extinguished),

and all valve covers must be in place before pouring media onto the

burner. It may also be necessary to temporarily cover the pilot assembly

(if equipped) to keep media out of it during this procedure.

GRANULE PLACEMENT

1. Pour the granules into the pan until they just cover the burner

tubes. Then pack the granules in the pan and around the burner

tubes. Add additional granules as needed to end with the granules

level with the top of the burner tubes. Slope the granules in the

front portions of the pan. See Fig. 15-1 and Fig. 15-3.

2. Place the separator screen over the granules such that the long

edges secure over the outside burner tubes, as shown in Fig.

15-2 and 15-3. If the long edges of the screen rise up and do not

rest ﬂ at, bend them downward as needed.

Note: The screen must correctly rest onto the burner pan. If it sits

too high; remove some of the granules to ensure a proper

ﬁ t. DO NOT allow for any granules to be above the screen.

GLASS / GEMS PLACEMENT

CAUTION: Glass pieces may have sharp edges. Be careful handling

the glass. Use hand protection, such as gloves, if

necessary.

1. Pour the glass / gems directly on top of the granules and screen

so that the burner pan is covered completely and evenly. Do not

exceed a 1" depth directly above the overall surface of the burner.

Note: At this stage the burner will function as designed;

however, more glass / gems may be added around the

burner for decorative purposes.

2. Add additional glass / gems around the burner pan as desired

(Fig. 15-4).