Owner`s manual

SYNCING THE REMOTE SYSTEM

17 Models

Ensure the burner system is off and completely cool.

Locate the 3-position switch on the remote receiver and

slide it to the REMOTE position. Next press the LEARN

button and release. See Fig. 38-1. A series of beeps will

be heard. Then press and hold the ON/HI button on the

remote transmitter, until a second set of beeps are heard.

The remote system is now synced. Refer to the LIGHTING

INSTRUCTIONS to test.

2VA Models

Note: Syncing the remote system will cause the burner

to ignite.

Ensure the burner system is off and completely cool.

The remote receiver (found on the rear of the burner

assembly) has a sync button (see Fig. 38-2).

Locate the OFF/REMOTE switch actuator on the left rear

of the burner. Slide the actuator to the right / REMOTE

position, then press the sync button and release. One beep

will be heard. Then press and hold the ON button on the

remote transmitter, until 4 rapid beeps are heard and the

pilot begins to spark. The remote system is now synced.

If ignition is not desired, press OFF on the remote to shut off.

FLAME DESCRIPTION

CLEANING AND SERVICING (cont.)

LEARN

REMOTE ONOFF

Fig. 38-1 Remote receiver sync detail

Fig. 38-3 Flame appearance

Remote receiver

SYNC button

(rear of burner assy)

Fig. 38-2 Sync Detail

LEARN

REMOTE ONOFF

Fig. 38-1 Remote receiver sync detail

Observe the ﬂ ames. The main burner ﬂ ames should be blue

at the base and a combination of blue/yellow at the body

and at the tips. They should be approximately 5-8" above

the logs, with the center ﬂ ame being the tallest. The ember

ﬂ ames should be

/4" to 5" above the embers (See 38-3

for example.)