Owner`s manual

31
LIGHTING INSTRUCTIONS - 2VA SERIES
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fi re or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device that automatically lights the pilot. DO NOT attempt to
light the pilot by hand.
B. BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the fl oor
because some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the fi re department.
C. Use only the control system or remote to light the pilot. This valve will not operate if the pilot is not lit and
stable.
D. Do not use this appliance if any part has been under water. Immediately call a qualifi ed service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
under water. Attempted operation may result in fi re or explosion resulting in property damage, personal
injury or loss of life.
ON
OFF
HI
LO
ON/OFF
Continuous Pilot
Fig. 31-3 Remote transmitter detail
HI/LO
fl ame
adjustment
key
ON
key
OFF
key
Signal
light
REMOTE LIGHTING
CAUTION: DO NOT attempt to light the pilot by hand.
Note: Steps 1 and 2 may not be required if previously done
during an earlier lighting.
1. Locate the ON/OFF switch at the front of the switch box.
Press the switch to the OFF (O) position. See Fig. 31-1.
2. Locate the OFF/REMOTE switch actuator on the left rear
of the burner. Slide the actuator to the right / REMOTE
position. See Fig. 31-2.
3. Locate the remote transmitter and press the ON key (see
Fig. 31-3). The ignition sequence will begin.
The remote receiver will emit an audible "beep"; then
the igniter will begin to spark. After the pilot lights and
is established, the valve will automatically open and
the burner will light. Adjust to the desired setting with
the remote transmitter. See the REMOTE OPERATING
INSTRUCTIONS section for details.
Note: The ignition sequence will take approximately 5
seconds.
WARNING: If the pilot fails to light within 10 seconds,
press the OFF button on the remote
transmitter or slide the OFF/REMOTE switch
actuator (left) to OFF to turn off the system.
Allow fi ve (5) minutes for any gas in the unit
to dissipate, then repeat step 2 above. IF YOU
SMELL GAS, SEE STEP B ABOVE.
If the pilot fails to light after several tries, turn all control/
remote system components to OFF and contact a qualifi ed
professional service technician.
Fig. 31-2
OFF/REMOTE switch actuator (left rear of burner)
ON
Fig. 31-1
Switch box,
ON/OFF
switch detail
OFF
I
O
Remote receiver
N/A