Owner`s manual
29
LIGHTING INSTRUCTIONS - 17 SERIES (cont.)
SHUTTING DOWN
MAIN BURNER ONLY (pilot will remain lit):
For remote shut down, press and hold the LO/OFF button
on the remote transmitter until the burner shuts off. If remote
is unavailable, slide the switch on the receiver to the OFF
position. For manual shutdown, turn the control knob
clockwise to PILOT.
BURNER AND PILOT (total shutdown):
If you do not plan on using your burner system for an
extended period (one week or more), you may extinguish
the pilot. This will conserve energy and save you money.
Push in the control knob slightly and turn clockwise to OFF.
PILOT BURNER CHECK/ADJUSTMENT
With the pilot burner lit and the control knob in the pilot
position, check the pilot system for proper fl ame size and
appearance (see Fig. 29-1). The pilot adjustment screw is
located on the front of the gas valve (see Fig. 29-1). Using a
small fl at head screwdriver, adjust the pilot screw to properly
size the fl ames. Turning the screw clockwise will lower the
fl ames, and turning it counterclockwise will raise them. Be
careful not to back the screw out of its threads.
The pilot fl ame should be a quiet, soft blue fl ame with yellow
tipping that encircles the thermocouple tip.
Fig. 29-1 Pilot adjustment detail
Pilot adjustment screw
PILOT VALVE
REMOTE OPERATING INSTRUCTIONS - 17 SERIES
ORIENTATION
Note: If the remote does not function, and batteries with
an adequate power level are installed, refer to the
SYNCING THE REMOTE section.
Prior to remote transmitter use, light the appliance per the
REMOTE LIGHTING section. Familiarize yourself with the
transmitter buttons, as illustrated in Fig. 29-2.
Identify the transmitter buttons:
• ON/HI BUTTON: This button turns the burner ON (when
the pilot is lit), and increases the fl ame height.
• LO/OFF BUTTON: This button decreases the fl ame
height and turns the burner OFF (pilot will remain lit).
FLAME HEIGHT
The fl ame height may be adjusted via the remote transmitter.
Press and hold the ON/HI button to increase the fl ame
height. Press and hold the LO/OFF button to decrease the
fl ame height. A click will be heard when the max/minimum
setting is reached.
Note: Continuing to hold the LO/OFF button will turn off
the burner. The pilot will remain lit.
LO/OFF
ON/HI
Fig. 29-2 Remote transmitter detail
Thermocouple