Owner`s manual

27
LIGHTING INSTRUCTIONS - 17 SERIES (cont.)
2. Locate the remote transmitter and press and hold the
ON/HI button (see Fig. 27-1). The ignition sequence
will begin.
Note: Continue holding the button to increase the fl ame.
A click will be heard when max fl ame height is
reached.
Note: Upon initial use or after an extended period of no
use, the ON/HI button may have to be pressed for
up to 3 seconds prior to functioning.
The remote receiver will emit an audible "beep";
then the valve will automatically open and the burner
will light. Adjust to the desired setting(s) with the
remote transmitter. See the REMOTE OPERATING
INSTRUCTIONS section for details.
Note: The ignition sequence will take approximately 5
seconds.
WARNING: If the burner fails to light within 5 seconds,
press and hold the OFF button on the
remote transmitter and/or slide the switch
to the OFF position. Allow fi ve (5) minutes
for any gas in the unit to dissipate, then
repeat steps 1 and 2 above. IF YOU SMELL
GAS, SEE STEP B AT BEGINNING OF
LIGHTING INSTRUCTIONS.
If the burner fails to light after several tries, turn all system
components to OFF and contact a qualifi ed professional
service technician.
MANUAL LIGHTING
1. Ensure the pilot is burning. Then locate the 3-position
switch on the remote receiver (see Fig. 27-2), and slide
the switch to the OFF position.
2. Turn the gas control knob counterclockwise to ON
(Fig. 27-3) to ignite the burner. The valve will open and
the burner will light.
Note: The ignition sequence will take approximately 5
seconds.
WARNING: If the burner fails to light within 5 seconds,
turn the control knob clockwise to
PILOT. Allow five (5) minutes for any
gas in the unit to dissipate, then repeat
step 2 above. IF YOU SMELL GAS, SEE
STEP B AT BEGINNING OF LIGHTING
INSTRUCTIONS.
If the burner fails to light after several tries, push in the
control knob slightly and turn clockwise to OFF, and contact
a qualifi ed professional service technician.
LO/OFF
ON/HI
Fig. 27-1 Remote transmitter detail
LEARN
REMOTE ONOFF
Fig. 27-2 Remote receiver (OFF for Manual Light)
ON
OFF
ON
PILOT
OFF
ON
PILOT
OFF
ON
PILOT
Fig. 27-3 Control knob detail (ON)
For Manual
Lighting, turn knob
counterclockwise to
ON position.