Owner`s manual

20
INSTALLING/REPLACING BATTERIES (IF APPLICABLE)
CAUTION: Ensure the unit is connected to the gas line
and has been tested for leaks before you insert
batteries.
CAUTION: Turn off the remote and/or burner and allow
the unit to completely cool prior to any battery
replacements.
REMOTE TRANSMITTER BATTERY
The remote transmitter requires one "12V" battery to operate
(included). Locate the transmitter, remove the lid (found on
rear), and properly insert the new battery as marked. Re-secure
the lid. See Fig. 20-1.
REMOTE RECEIVER / SWITCH BOX BATTERIES
Remote receiver
The remote receiver requires 4 AA batteries to operate
(included). Locate the remote receiver and turn it over. Slide
open the lid, and properly insert the new batteries as marked.
See Fig. 20-2.
Replace the lid, then re-position the remote receiver in the
fi replace. (Ensure the plastic cover is properly in place over
the receiver.)
Switch Box
The burner system requires 4 AA batteries to operate (included).
Locate the switch box and turn it over. Detach the battery box
from the velcro. Use a small Phillips screwdriver to remove the
screw found on the bottom of the battery box, then remove
the battery lid. Properly insert the new batteries as marked.
See Fig. 20-3.
Replace the battery lid using the screw, replace the battery box
onto the velcro, and re-position the switch box in the fi replace.
Important: Low/dead batteries will affect burner system
operation. Replace batteries any time the
burner will not turn on.
"AA" batteries
Fig. 20-3 Switch box batteries
Fig. 20-1 Transmitter battery
Remove
lid for
"12V"
battery
access
"AA" batteries
Fig. 20-2 Remote receiver batteries