Owner`s manual

18
INSTALLATION (cont.)
24" Log Sets Only
For 24" log sets, continue with the steps below to complete placement.
For 18" log sets, go back to the previous page. For 30" log sets, proceed to the following page.
7
6
5
3 4
Separate the bryte coals into small pieces and
evenly place them over the glowing embers in
the area shown.
Place the left top log (log #7) as shown.
Place the center top log (log #6) as shown.
Place the center middle log (log #5) as shown.
Place the left and right middle logs (logs #3 & #4)
as shown.
Note: The conditions/environment of each setup will slightly vary. After installation of your unit is
complete, follow the LIGHTING INSTRUCTIONS section to light the burner. The burner system
will reach optimal performance and appearance after approximately 20 minutes.