Owner`s manual

Fig. 15-1 Place lava granules

INSTALLATION (cont.)

LAVA GRANULES (DECORATIVE)

1. Spread the supplied lava granules on the ﬂ oor of the

ﬁ replace, around the front and sides of the burner system

(see Fig. 15-1). The lava granules may be placed around

the switch box. Leave the front of the box clear for control

access.

Note: DO NOT place any lava granules on the burner system,

or behind it.

SAND/VERMICULITE PLACEMENT

The sand/vermiculite supplied with the unit is specially selected

for use with either propane or natural gas. It maximizes ﬂ ame

distribution and reduces carbon buildup.

CAUTION: Use only sand for natural gas burners and

vermiculite for propane gas burners.

1. Fill the burner pan completely with the sand/vermiculite

(see Fig. 15-2). Avoid spilling the sand/vermiculite on

the pilot assembly.

2. Slope the sand/vermiculite at the same angle as the burner

pan. This is important to ensure quiet lighting and even

ﬂ ame distribution. See Fig. 15-3.

INITIAL GLOWING EMBERS PLACEMENT

Important: The supplied embers are to be applied at several

stages of installation. You may end up with some

unused embers at the end of installation. If so,

store them for later use/replacement.

Sprinkle a portion of the glowing embers A lightly and evenly

over the entire surface of the sand/vermiculite as shown in Fig.

15-4. Break up any clumps that may have developed during

shipment. Store unused embers for later use/replacement.

Important: Place the glowing embers A lightly and evenly

exactly as shown. DO NOT over apply.

Fig. 15-2 Place sand/vermiculite

Fig. 15-3 Sand/vermiculite detail

Fig. 15-4 Place glowing embers A

Place embers A exactly as shown

Fill pan

with sand/

vermiculite

Fig. 15-5 Keep pilot clear

KEEP CLEAR

KEEP SAND/VERMICULITE, LAVA GRANULES,

AND ALL FOREIGN OBJECTS AWAY FROM THE

PILOT ASSEMBLY DURING MEDIA PLACEMENT

AND AT ALL TIMES.