Owner`s manual

14
REFER TO THE PARTS LIST WHEN FOLLOWING INSTALLATION
INSTRUCTIONS.
24" 2VA burner model shown here.
BURNER INSTALLATION
1. MAKE SURE THE FIREPLACE GAS SUPPLY IS TURNED
OFF.
2. Locate the gas-supply stub inside the fi replace and remove
the cap, if attached (reference Fig. 14-1).
CAUTION: When removing the cap, make sure the stub does not
turn, loosening the connection inside the wall.
3. Place the burner system in the fi replace. Center the burner in
the fi replace. (Reference Fig. 14-2 for orientation.)
4. Be sure gas to the fi replace is off. Remove the adapter that
is loosely connected to the fl ex connector (coming off of the
burner system). Attach the adapter to the gas-supply stub using
a pipe compound resistant to all gasses. Tighten securely.
Then attach the open end of the fl ex connector to the adapter.
Tighten securely (see Fig. 14-1).
5. LEAK TEST: Turn on the fi replace gas supply, and test at
all connections for leaks using the appropriate soapy water
solution. If bubbles appear, a leak is present. Turn off the
gas and tighten at all connections. Repeat until no leaks are
present. If a leak persists, turn off the gas supply and contact
the local gas company or dealer. NEVER USE A FLAME TO
CHECK FOR LEAKS.
6. At this stage the burner system batteries are to be installed
(if applicable). Reference the INSTALLING/REPLACING
BATTERIES section for details.
7. Remote receiver: place the plastic cover over the receiver,
then place at the rear right corner of the fi replace. Place as
far from the burner system as possible. See Fig. 14-2 & Fig. 14-3.
Switch box: Place on its side, at the rear right corner of
the fi replace. It should rest with its bottom as near as possible
and facing the fi replace wall. It must not be placed directly
next to the burner pan area to avoid damage to the batteries.
See Fig. 14-2 & Fig. 14-3.
Important: Ensure that the box wire remains away from the
burner system and its fl ame during operation.
The Real-Fyre burner system must be installed by a qualifi ed professional service technician. Instructions must
be followed carefully to ensure proper performance and full benefi t from the burner system. Check to be sure
the burner system is designed and labeled for the type of gas (natural or propane gas) supplied to the
fi replace. Fireplace fl oor must be level, clean, and smooth.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifi cally approved with this appliance may result in property damage or personal injury.
INSTALLATION
Fig. 14-2 Place switch box / receiver
Fig. 14-1 Connect gas supply
Flex connector
Adapter
Gas supply stub
IMPORTANT
For all valves, the air MUST be purged from the gas line before the pilot will light and burn properly. The time
needed to purge will depend on the length of the gas line to the unit and the amount of time since the unit or
gas line was last used. It may take several minutes before all the air is purged and the pilot will light and burn
properly. Reference the LIGHTING INSTRUCTIONS section in this manual.
Fig. 14-3 Proper box/receiver placement
Place switch box:
• Rt rear corner,
on side,
• exposed side against
fi replace wall
DO NOT
place box
in this area
Place switch box / receiver
(2VA model shown here)
Place receiver:
• Rt rear corner
• Ensure plastic
cover is in place