Owner`s manual

9
1. The burner gas inlet is located in front of the gas
valve (Figure 3). Use tefl on tape or pipe compound
on all pipe thread male connections, except where
brass to brass.
FOR THE G46 AUTOMATIC MILLIVOLT VALVE Attach
the connector kit 3/8" adaptor to the brass elbow (Item
No. 24) on the valve. The log set user should make
themselves familiar with the valve control layout before
installing the burner into the fi replace.
2. Next clamp the log locators onto the grate fi ngers
(one in from either end). The log locators will fi t on either
side of the grate fi nger (see Figure 4a and b). Align the
locator screw so that it projects down into the locator
holes on the burner. Attach nuts to screws and fi nger
tighten only. Place the bottom log on the grate (see Figure
4c) and align the log against the locator. Fully tighten
the screws and then remove the logs and grate until
completing gas connection and granule placement.
3. Position the burner in the center rear of the fi replace.
Connect the connector kit tubing (Item 16) to your gas
supply. Be sure that the burner assembly and the valve
remain in alignment. If the valve shifts position during
installation, the burner assembly may not sit fl at in the
fi replace, causing improper gas fl ow. It may also cause
interference with the control knob operation.
• Make sure that the safety control system is in the
"OFF" position.
• Turn on the gas to the fi replace and check for leaks
at all connections by using a soapy water solution.
Never use an open fl ame to check for leaks.
• Light the pilot (pages 16-23) and check for proper
adjustment. If the pilot needs to be adjusted, follow the
instructions on page 24. Turn the pilot off.
• Position the grate on the burner (Figure 4c). Push the
burner-grate assembly as far as possible to the rear of
the fi replace, then remove the grate.
NOTE: REFER TO PARTS LIST (PAGE 4) WHEN FOLLOWING THESE INSTRUCTIONS.
INSTALLATION OF LOG SET IN YOUR FIREPLACE
(be sure the gas to the fi replace is off)
IMPORTANT:
Log locators may be installed in either confi guration (A or B),
depending on burner size. Adjust as necessary to ensure screws
fi t in locator holes in burner. This secures the burner and grate
from movement, and keeps the logs in place for optimum log
set operation.
INSTALLING YOUR REAL-FYRE GAS LOG SET (Continued)
NOTE: IF YOUR LOG SET IS A G46-01(P) MODEL CONTINUE
FOLLOWING THE INSTRUCTIONS ON PAGE 10.
FOR ALL OTHER MODELS PROCEED TO PAGE 11.
Figure 4B
B
A
Figure 4A
HEAT
CHAMBER
LOG
LOCATORS
FRONT
BOTTOM
LOG
LOG
LOCATOR
SCREW
GRATE
BURNER
REAR
BOTTOM
LOG
Figure 4C
Log locator
Grate
Burner