Owner`s manual

24
The pilot burner is preset at the factory and normally
should not require adjustment. However, if adjustment
is necessary, the following steps should be taken:
With the pilot burner lit and the control knob in the pilot
position, use a long narrow screwdriver to turn the
pilot adjustment screw (located on front of valve). Turn
the adjustment screw slowly clockwise to reduce the
fl ame, or counterclockwise to increase the fl ame. The
adjustment screw can be turned so that the pilot fl ame
is completely extinguished. The pilot fl ame should be a
quiet soft blue fl ame with yellow tipping which encircles
the thermocouple tip.
Turn the control knob to the "ON" position to assure
proper ignition of the log set.
PILOT BURNER ADJUSTMENT (G46 MANUAL)
Example of proper pilot burner fl ame
and proper pilot/thermocouple alignment
PILOT
ADJUSTMENT
Figure 26
Thermocouple
Thermopile
Figure 28
Example of proper pilot burner fl ame and
proper pilot / thermopile alignment
PILOT ADJUSTMENT SCREW
ON
OFF
PILOT
Figure 27
Position of Pilot Adjustment Screw
PILOT BURNER ADJUSTMENT
The pilot burner is preset at the factory and should
normally not require any adjustment. However, should
adjustment be necessary, the following steps should
be taken:
1. Pull the burner forward so that you can access the
pilot burner adjustment screw.
2. Light the pilot burner (see pages 16-23 for "Lighting
Instructions").
3. With the control knob in the "PILOT" position,
carefully remove the cap screw and gasket covering the
safety pilot adjustment screw on the control valve.
4. Using a long narrow screwdriver, turn the pilot
adjustment screw (Figure 27) slowly clockwise to
reduce the fl ame or counterclockwise to increase the
fl ame. The adjustment screw can be turned so that the
pilot fl ame is completely extinguished. The pilot fl ame
should be a quiet soft blue fl ame with yellow tipping
which encircles the tip of the thermopile (Figure 28).
5. Reassemble the cap screw and gasket to the valve
body, insuring that the cap screw and gasket are fi rmly
seated on the valve body. Turn the control knob to the
"ON" position to assure proper ignition of the log set.
PILOT BURNER ADJUSTMENT (G46-11 REMOTE)
California Proposition 65 Warning
As a result of Proposition 65, the State of California lists substances known to cause cancer or reproductive harm. We want you to
be aware of the following so you can minimize possible exposure to substances on the State’s list related to natural gas. Natural gas
combustion produces substances on the State’s list such as soot. To minimize exposure, operate gas equipment according to the
manufactures’ instructions. Products of gas combustion can be removed through appliance vents, including chimneys. When your
log set is operating, the damper must be fully open.
California Advertencia de la Proposición 65
Como resultado la Proposición 65, el Estado de California ha publicado una lista de substancias que se sabe producen cáncer o
defectos en la reproducción. Deseamos advertirle de lo siguiente, de modo que Ud. pueda minimizar la posible exposición a las
substancias relacionadas con los servicios de gas natural e incluidas en la lista del estado.
Combustión de gas natural produce algunas de las substancias que fi guran en la lista del estado, tales como el hollín. Para mini-
mizar la exposición debe hacer funcionar sus equipos de gas de acuerdo con las instrucciones del fabricante. Los productos de
combustión de gas pueden removerse a través de respiraderos, incluyendo chimeneas. Cuando su equipo de leña esté encendido,
el regulador de tiro de la chimenea debe estar completamente abierto.