Owner`s manual

If you have purchased this style of log set, follow the instructions below.

NOTE: The logs for the CHD Charred Oak Set are illustrated.

Log styles and sizes will vary depending upon the Charred Series log set ordered.

NOTE: INSTRUCTIONS ON THE FYREBED MAY NOT BE APPLICABLE

The COALS FYREBED (see Figure 13) supplied with your Charred log set, ﬁ ts onto the back of the burner

pan. Place it centrally on the back so the outer front tabs hang over the pan (see Figure 14). Set it so it is

over the pilot assembly, but high enough that it does not interfere with the operation of the pilot (see Figure

13). Cover the surface of the COALS FYREBED with the GLOWING EMBERS, supplied with your Charred

Series log set, making sure to keep the GLOWING EMBERS clear of the pilot assembly. For best glowing

performance, they should be applied evenly and pulled slightly apart so the ﬁ bers are somewhat loose. (It

is not necessary to pile the entire bag of the GLOWING EMBERS). Center ﬂ ame must be clearly visible, or

excessive sooting could occur.

Figure 15

Figure 16

Figure 17

Figure 18

Figure 13 Figure 14

INSTALLING YOUR REAL-FYRE GAS LOG SET (Continued)

CHARRED SERIES LOG PLACEMENT - 24" Charred Oak (CHD) set shown

Step 1. Place the long bottom rear log (Log #1) on the back of the grate with the ﬂ at hollow side facing the

rear of the ﬁ replace. Push the log up against the log locators.

Step 2. Place the two sections of the front log (Log #2L & 2R) on the front of the grate and up against the

log locators. The charred sections should be facing each other, approximately one inch apart at the

top.

Step 3. Place the two top knot hole logs (Logs #3 & #4) so that one end rests on each front log section and

the other end rests on the rear log, as shown in Figure 16. The charred sections should be over the

opening between the front and rear logs.

Step 4. Place the top logs (Logs #5 & 6) as shown in Figure 17, with Log # 5 resting on left hand knot hole

log #3 and the left front log (Log #2L), and Log #6 resting across both knot hole logs to the rear.

Step 5. Place the additional top log (Log #7) so it rests near on the right hand knot hole log (Log # 4) and

on the right front bottom log section (Log # 2R ) as shown in Figure 18.