Owner`s manual

12
Note: For Charred Series see Page 14
For Western Campfyre Series see Page 15.
Proper log placement is important to insure proper performance of your Real-Fyre gas log set. Be sure to follow
the log placement instructions carefully. 3 optional log placement patterns, an exclusive feature of Real-Fyre
gas logs, are explained below.
REAL-FYRE GAS LOG SETS 18"-30".
24" Woodland Oak (WO) log set shown.
For all Options - Step 1. Place the rear bottom log (Log #1) on the
back of the grate (Figure 9), and slide it forward against the log locators.
Place the front log (Log # 2) on the front of the grate and slide it back
against the log locators. The log locators ensure that adequate space
between the logs is maintained for a cleaner burn.
Option 1 - Step 2. Place the the middle log (Log #4) to rest on the front and rear bottom logs as shown
in Figure 10A. Place Log #3 so it rest on Log #4 and the front log, as shown in fi gure
10A. Ensure they are placed across the space between the logs.
Option 1 - Step 3. Place the top logs (Logs #5 & 6) as shown in Figure 10B, with Log # 5 resting on Log
#3 and the front log, and Log #6 resting on the rear log and Log #4.
Option 2 - Step 2. Place the middle logs parallel as shown in Figure 10A. Log #3 is placed with one end
on the front log, the other end resting on Log #4.
Option 2 - Step 3. Place Log #5 resting on the front log and the left middle log, and Log #6 resting on the
rear log and the right middle log as in Figure 10C.
Option 3 - Step 2. Place the middle logs (Logs #3 & 4) so they are parallel, resting on the front and rear
logs across the space as shown in Figure 10D.
Option 3 - Step 3. Place top logs #5 & 6 so they are parallel and rest across Logs #3 & 4, as in Figure
10D.
INSTALLING YOUR REAL-FYRE GAS LOG SET (Continued)
Figure 10C
Option 2
Steps 2 & 3.
4
3
6
5
CAUTION: BURN HAZARD.
LOGS WILL REMAIN HOT FOR SOME TIME AFTER USE.
YOU MUST MAINTAIN THE LOG LAYOUT AS SHOWN TO ENSURE PROPER
OPERATION OF YOUR LOG SET.
IF YOU NEED TO REPOSITION ANY LOG TO MAINTAIN THE PROPER LAYOUT,
USE HEAT RESISTANT GLOVES OR ALLOW LOGS ADEQUATE TIME TO COOL BEFORE HANDLING.
Figure 9
2
1
Figure 10D
Option 3
Steps 2 & 3.
3
4
6
5
4
6
5
3
Option 1
Step 2.
Figure 10A
Option 1
Step 3.
Figure 10B