Owner`s manual

* We recommend that before you install your log set, you familiarize yourself with the control valve layout. This will help

you to be conﬁ dent operating the log set when fully installed.

WARNING

If you do not follow these instructions exactly, a ﬁ re or explosion may result, causing property

damage, personal injury, or loss of life.

TO LIGHT THE PILOT AND MAIN BURNER

1. STOP! Read the safety information above.

2. Tur n OFF any electrical appliance (such as the Peterson warm air circulator system) if used with the log set.

3. Place the switch (marked I = IGNITE; O = OFF,

Fig. 25-1) in the OFF position.

4. Wait ﬁ ve (5) minutes to clear out any gas. If you then smell gas, STOP! Follow the instructions on page 1.

5. Press the switch on top of the pine cone to the I position (see

Fig. 25-2). There will be a rapid series of

sparks at the pilot (cobra) head. These sparks cease when the pilot ﬂ ame is lit and stable. When the pilot

becomes stable, the electronic valve will open and light the main burner.

CAUTION: If the gas set does not ignite within 20 seconds, stop, wait 5 minutes, and then repeat TO LIGHT

THE PILOT AND MAIN BURNER.

LIGHTING INSTRUCTIONS - 01 VALVE

THIS UNIT (G46-01) HAS A NON-STANDING PILOT.

TO TURN OFF THE G46-01 REMOTE GAS LOG SET

1. Press the switch on top of the pine cone to the O position (O = OFF,

Fig. 25-3). The gas ﬂ ow will cease,

and all ﬂ ames (main burner and pilot) will go out.

If this unit was shipped with a remote, or if a remote system was installed later, read and follow the

separate remote instructions to operate the burner remotely.

Pine cone switch

Fig. 25-1

Fig. 25-2

Fig. 25-3

Pine cone switch in

ON position

Pine cone switch in

OFF position

FOR YOUR SAFETY, READ BEFORE LIGHTING

The Real-Fyre

G46 Series gas log set has a pilot that can be lit by hand using the piezo ignitor. When lighting

the pilot, follow these instructions exactly.

BEFORE LIGHTING, smell all around the gas log set area for gas. Be sure to smell next to the ﬂ oor as some gas is

heavier than air and will settle on the ﬂ oor. IF YOU SMELL GAS, FOLLOW THE INSTRUCTIONS ON PAGE 1.

Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by

hand, don't try to repair it. Call a qualiﬁ ed professional service technician. Force or attempted repair may result in

ﬁ re or explosion.