Owner`s manual

REV 4 - 0705040838

No.L-A2-21507

If you have purchased this style of log set, follow the instructions below.

Note: The logs for the CHD Charred Oak Set are illustrated.

Log styles and sizes will vary depending upon the Charred Series log set ordered.

Note: INSTRUCTIONS ON THE EMBER BED MAY NOT BE APPLICABLE.

The ember bed (see

Fig. 18-1), supplied with the charred log set, ﬁ ts onto the back of the burner pan.

Place it centrally on the back so the outer front tabs hang over the pan (see Fig. 18-2). Set it so it is over the

pilot assembly, but high enough that it does not interfere with the operation of the pilot (see Fig. 18-1). Cover

the surface of the ember bed with the glowing embers, supplied with the Charred series log set, making sure

to keep the Glowing Embers clear of the pilot assembly. For best glowing performance, they should be applied

evenly and pulled slightly apart so the ﬁ bers are somewhat loose. (It is not necessary to pile the entire bag of

the glowing embers.) Center ﬂ ame must be clearly visible, or excessive sooting could occur.

Fig. 18-3

Fig. 18-4

Fig. 18-5

Fig. 18-6

Fig. 18-1

Fig. 18-2

EMBER BED SETUP

Step 1. Place the long bottom rear log (Log #1) on the back of the grate with the ﬂ at, hollow side facing the

rear of the ﬁ replace. Push the log up against the log locators.

Step 2. Place the two sections of the front log (Logs #2L & #2R) on the front of the grate and up against the

log locators. The charred sections should be facing each other, approximately 1" apart at the top.

Step 3. Place the two top, knot-hole logs (Logs #3 & #4) so that one end rests on each front log section and

the other end rests on the rear log, as shown in

Fig. 18-4. The charred sections should be over the

opening between the front and rear logs.

Step 4. Place the top logs (Logs #5 & #6) as shown in

Fig. 18-5, with Log #5 resting on the left-hand knot-

hole log (Log #3) and the left front log (Log #2L), and Log #6 resting across both knot-hole logs to

the rear.

Step 5. Place the additional top log (Log #7) so it rests on the right-hand knot-hole log (Log #4) and on the

right front bottom log section (Log #2R), as shown in

Fig. 18-6.

CHARRED OAK SET LOG PLACEMENT

Slide the ember bed over the back center of the

burner pan

Pilot

Ember bed

Periodically observe the ﬂ ames. Flames should be aproximately 22"-24" above the ﬁ replace ﬂ oor, a little blue at

the base mostly orange and yellow ﬂ ames (see Fig. 19-1). The ﬂ ames should impinge on the logs and grating as

little as possible to avoid sooting the logs or the grating.