Owner`s manual

16
REV 4 - 0705040838
No.L-A2-21507
Note: For Charred series, see p. 16. For Western Campfyre
TM
series, see p. 17.
Proper log placement is important to ensure proper performance of the Real-Fyre
®
gas log set. Be sure to follow
the LOG PLACEMENT INSTRUCTIONS carefully. Three optional log placement patterns, an exclusive feature of
the log set, are explained below.
18"- 30" GAS LOG SETS
FOR ALL OPTIONS
WOODLAND OAK LOG PLACEMENT
Fig. 16-4
Option 2
Steps 2 & 3
4
3
6
5
CAUTION: Burn hazard. Logs will remain hot for some time after use. You must maintain the log
layout as shown to ensure proper operation of the log set. If you need to reposition
any log to maintain the proper layout, use heat-resistant gloves or allow logs adequate
time to cool before handling.
Fig. 16-5
Option 3
Steps 2 & 3
4
6
5
3
Option 1
Step 2
Fig. 16-2
Option 1
Step 3
Fig. 16-3
6
5
3
4
Fig. 16-1
2
1
24" Woodland Oak (WO) log set shown.
Step 1:
Place the rear bottom log (Log #1) on the back of the grate (Fig. 16-1),
and slide it forward against the log locators. Place the front log (Log #2)
on the front of the grate and slide it back against the log locators. The
log locators ensure that adequate space between the logs is maintained
for a cleaner burn.
OPTION 1
Step 2:
Place the middle log (Log #4) to rest on the front and rear bottom logs, as shown in Fig. 16-2. Place Log #3 so
it rests on Log #4 and the front log, as shown in
Fig. 16-2. Ensure they are placed across the space between
the logs.
Place the top logs (Logs #5 & #6) as shown in
Fig. 16-3, with Log #5 resting on Log #3 and the front log,
and Log #6 resting on the rear log and Log #4.
Step 3:
OPTION 2
Step 2:
Place the middle logs parallel, as shown in
Fig. 16-4. Log #3 is placed with one end on the front log, and
the other end resting on Log #4.
Step 3:
Place Log #5 resting on the front log and the left middle log, and Log #6 resting on the rear log and the right
middle log, as shown in
Fig. 16-4.
OPTION 3
Place the middle logs (Logs #3 & #4) so they are parallel, resting on the front and rear logs across the space,
as shown in
Fig. 16-5.
Step 2:
Step 3:
Place top Logs #5 & #6 so they are parallel and rest across Logs #3 & #4, as shown in
Fig. 16-5.