Owner`s manual

REV 4 - 0705040838

No.L-A2-21507

SECURING THE BURNER

The gas log set has two securing holes at the front of the burner pan heatshield (see PARTS LIST and Fig.

15-1

for location). Mark the center point of each hole and drill a

" pilot hole (one for each side) into the

ﬁ replace ﬂ oor. Secure with

" anchor bolts.

GRANULE PLACEMENT

Fill the burner pan completely with granules (Item 13). Slope the granules at the same angle as the burner

pan. Do not allow granules to spill over the front lip, sides, or back of the burner.

DO NOT PLACE GRANULES

ON IGNITOR SHIELD OR KNOB SHIELD.

EMBER PLACEMENT

After breaking up any clumps, sprinkle embers (Item 14) lightly and evenly over the entire surface of the

granules. You may sprinkle the embers (not the granules) over the knob and ignitor shields, making sure to keep

the embers clear of the pilot assembly.

Embers around the pilot will block airﬂ ow, causing the pilot to overheat and shut down the system.

To check operation, light the pilot and burner (see the relevant LIGHTING INSTRUCTIONS section).

IMPORTANT

For all valves, the air MUST be purged from the gas line before the pilot will light and burn properly.

The time needed to purge will depend on the length of the gas line to the unit and the amount of time

since the unit or gas line was last used. It may take several minutes before all the air is purged and

the pilot will light and burn properly. Follow the relevant LIGHTING INSTRUCTIONS in this manual.

INSTALLING THE GAS LOG SET (Cont.)

Fig. 15-1

24" unit shown

(11 valve)

See parts list for

grate differences

Embers

Ignitor shield

Locator hole

Log locator

bolts

Pilot assembly

Burner

securing

hole

GRATE PLACEMENT

Carefully center the grate over the burner. Place the log locator bolts in the oval locator holes of the heatshield

assembly (see Figs. 11-3 and 13-1) so that the burner pipe is behind (not directly under) the front bar of the

grate. This will help prevent sooting. Next proceed to LOG PLACEMENT.

WARNING

Failure to position the parts in accordance with these diagrams or failure to use only parts

speciﬁ cally approved with this appliance may result in property damage or personal injury