Owner`s manual

14
REV 4 - 0705040838
No.L-A2-21507
CONNECTING THE IGNITION PACK TO THE G46-01(M)(P) VALVE
The G46-01-xx(M)(P) valve comes complete with the wiring harness connected to the pine cone switch. You
may wish to ensure it is correctly connected before fi nally connecting the three wires to the valve, as below.
PINE CONE PLACEMENT
The designer pine cone incorporating the
control switch is aesthetically designed
and is an integral part of the operation of
the log set. The pine cone can be placed
as close to the valve as you desire, but
never closer than 4" from the fl ame.
CAUTION: THE PINE CONE MAY
BE HOT DURING AND
DIRECTLY AFTER
OPERATION OF THE
GAS LOG SET.
O
(Drawings not to scale)
Wiring diagram for 01 remote switch
INSTALLING THE GAS LOG SET (Cont.)
SPECIAL INSTRUCTIONS FOR G46-01-xx(M)(P) MODELS
Installing pine cone with switch for 01M models
TO CHECK THE WIRING ASSEMBLY:
A. Check that the wiring harness is fi tted tightly into the
connector on the green ignitor pack in the rear of the
pine cone (Fig. 14-1).
B. Check that the female connectors on the two black wires
from the pilot assembly (wires marked "I" and "S") are
inserted fully into the male connectors on the ignitor
pack (
Fig. 14-2).
C. Check the connection of the red and black wires of the
wire harness to the respective counterpart wires from
the battery holder (red-red and black-black). The two
brown wires should be connected to the switch.
Note: The two spare brown wires with coated male
connectors are used to connect a remote system
(if equipped).
D. Connect the wires to the valve in the following order
(see
Fig. 14-2):
Orange wire marked THTP - to THTP connector on valve
Black wire marked TP - to TP connector on valve
Green wire marked TH - to TH connector on valve
The diagram below shows the wiring layout for the complete
unit.
CHECK CONNECTIONS
“I” WIRE
“S” WIRE
WIRE HARNESS
CONNECT OR
IGNITOR PACK
A
Fig. 14-1
INSTALLING OR REPLACING BATTERIES FOR IGNITION
MODULE PACK
Two 1.5-volt (D-cell) alkaline batteries are supplied with the log set.
To install or replace batteries, remove the green ignition module
pack, held in place with a Velcro strip, from the rear of the pine cone
receiver (
Fig. 14-3). Remove the battery holder and old batteries
from the pine cone. Replace (or install) batteries into the battery
holder, making sure they are installed according to the diagram in
the battery holder. Replace the holder, pressing it fi rmly against
the Velcro strip. Replace the ignition pack and press it fi rmly into
place. The ignition system is now ready to operate.
Note: For the system to work properly, it is suggested that
you replace the batteries annually with fresh batteries.
Always replace all the batteries at the same time.
D
Fig. 14-2
Fig. 14-3
"S" wire
Velcro strips
Pine cone
cover
with switch
Battery holder
with batteries
Ignition module pack
Switch
Pine cone
2 wires
to
switch
(brown)
Ignitor pack
To battery
holder (red)
Orange
wire
marked
THTP
Black
wire
marked
TP
Green
wire
marked
THTP
To battery
holder (black)
To pilot assembly
probes
Valve magnet
wire (black)
(Do not remove)
G46
electronic
valve
Orange (THTP)
I
S
S
I
Green (TH)
Wire harness
Black (TP)
"I" wire
B
Check Connections
Wire harness
connector
Ignitor pack